AC Manual Blower Motor - Dock Pedestal, Red Handle

A freestanding AC control pedestal that bolts directly to your dock surface, housing a manual control station with high-visibility red handle valves for direct pneumatic control of your lift. Available in 1-valve or 2-valve configurations, with hose barbs matched to your lift's 1" or 1.25" air hose. The weatherproof pedestal enclosure keeps the blower switch, valves, and operating instructions protected and within easy reach, combining consistent high-volume AC airflow with simple manual oversight in a marine-grade housing built for long-term waterfront durability.

Freestanding Dock Pedestal

Unlike post-mounted control boxes, this station is built into a freestanding pedestal that bolts securely to your dock surface through a flanged base, putting the controls at a comfortable standing height right where you need them. The hinged lid lifts to reveal the blower switch, manual valves, and clearly printed operating instructions, then closes to shield everything from sun, rain, and spray when not in use. The granite-finish enclosure resists UV fading and blends cleanly into any dock or shoreline setting.

AC Blower Motor Performance

The AC-powered blower motor delivers consistent, high-volume airflow through the valve manifold, providing rapid inflation of a single lift tank or efficient inflation of dual tanks, eliminating the physical effort of manual pumping and outperforming lower-capacity compressors. A lighted blower on/off rocker switch sits behind the lid for at-a-glance status, and the integrated design keeps all wiring and components enclosed within the pedestal for a clean, organized dock.

Red Handle Manual Interface

The number of valves is determined by the number of air hoses on your lift, so choose 1 valve for a single-hose lift or 2 valves for a lift with 2 air hoses. Each valve has its own high-visibility red handle, making it easy to identify and operate each line quickly, even in low-light dock conditions. The manual valves provide precise regulation of airflow with immediate adjustments to lift status, and on the 2-valve configuration each line can be adjusted independently to keep the vessel stable and level. With the operating instructions printed right inside the lid, launching, holding, and lifting follow a simple, repeatable sequence every time.

Matched Air Hose Barbs

Air displacement lifts use either 1" or 1.25" air hose, depending on the lift manufacturer and system design. Each station is fitted with hose barbs sized to match the internal diameter (ID) of your hose for a proper seal, correct airflow, and optimal performance. The barb fittings are not easily interchangeable once installed, so measure the inside diameter of your hose and confirm the correct size when ordering.

External GFCI Protection

This station uses an external GFCI, which is typically suitable for lifts in fresh water with a roof or full overhead cover. When the lift is protected from direct weather exposure in a less corrosive fresh water environment, an external GFCI provides appropriate protection when installed correctly at the power source. If your lift is in salt or brackish water or has no overhead cover, contact us before ordering.